Skip to content

Repairing a Behringer BCF2000

My beloved Behringer BCF2000 midi controller was already broken when I bought it used over 10 years ago. The unit has 8 motorised faders and 8 rotary controllers with LED rings so it’s great to use with midi feedback and it’s a good bang for the buck. I was surprised to see that this model is still sold on-line despite the fact the Behringer has put out a new model.

The guy that sold this unit to me didn’t tell me that fader one didn’t move by itself and something was loose inside the case. Now, after my successful repair of my wife’s midi keyboard I’ve gotten hubris and think that I can repair anything. Well, at least I can repair simple stuff that doesn’t contain any advanced troubleshooting.

I was smart enough to see if there was any disassemble manuals on-line and I found a PDF document that detailed how to tighten up the belts for the motorized faders. Sadly there’s quite a few steps to reach the faders. Once there I realised that fader one’s belt and one of the screws had come loose and it was really easy to attach them again. When I lifted the panel covering the faders the belt from fader eight came loose too but it was as easy to fix as fader one.

While I was inside the unit I figure I could tighten up the fader belts as described in the PDF. Unfortunately I tightened three of them too much so I had to go unscrew everything once again to loosen the tight belts. This time I did’t put all of the pieces back before testing which was good since I also needed to put some hot glue on the ribbon cable connectors so that the cables stays in place.

By this time I had figured out that I wanted a nice way to show off the working motorized faders. I could probably have done this quickly in a DAW but I wanted to do it in Vezér, a MIDI/OSC/DMX timeline app. I quickly programmed the eight waves seen in the video.

Right before putting back the two side panels I noticed that the holder for the power button had came loose from the case. I epoxy glued that back before doing the final assembly. Now the machine is in better shape than ever.

Since I published this article, the PDF document has disappeared from the web. I contacted the author Nathan Parrow and he was kind enough to let me host it so that we all can use it for future repairs. 

5 Comments

  1. Dheen Dheen

    My bcf 2000 usb connection stopped working .. but 5pin midi cable working fine. my local engineer said it’s usb IC is gone. dont know if its true , there is no behringer service center in my place.

  2. Ben Ben

    I’m looking to get one of these and found one cheap but apparently the 7 fader only goes up half way, to 64, do you think if I brought this it would be something relatively straight forward to fix?

  3. Robson Robson

    BCF2000.pdf link is not working send me the pdf please

  4. ZeroZero ZeroZero

    The PDF has disappeared. How do you get into the thing?

Leave a Reply to The Midi Thief Cancel reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.